| 马焕,黄元波,杨晓琴,郑云武,陶磊,郑志锋.响应面法优化磷钨酸介孔分子筛催化制备大豆油基多元醇[J].中国油脂,2017,42(4):.[MA Huan, HUANG Yuanbo, YANG Xiaoqin, ZHENG Yunwu, TAO Lei, ZHENG Zhifeng.Optimization of preparation of soybean oil-based polyols catalyzed by HPW-based mesoporous sieve using response surface methodology[J].China Oils and Fats,2017,42(4):.] |
| 响应面法优化磷钨酸介孔分子筛催化制备大豆油基多元醇 |
| Optimization of preparation of soybean oil-based polyols catalyzed by HPW-based mesoporous sieve using response surface methodology |
| |
| DOI： |
| 中文关键词: 环氧大豆油 大豆油基多元醇 响应面法 磷钨酸 介孔分子筛 |
| 英文关键词:epoxidized soybean oil soybean oil-based polyols response surface methodology phosphotungstic acid mesoporous sieve |
| 基金项目: |
|
| 摘要点击次数: 1014 |
| 全文下载次数: 0 |
| 中文摘要: |
| 采用响应面法对磷钨酸介孔分子筛催化环氧大豆油制备大豆油基多元醇进行了优化研究。结果表明：以甲醇作为开环反应试剂，磷钨酸介孔分子筛可较好地催化环氧大豆油开环制备大豆油基多元醇；通过Box-Behnken设计，利用Design-expert 8.0软件进行二次回归分析，确定大豆油基多元醇最佳制备条件为反应时间3 h、磷钨酸介孔分子筛用量为环氧大豆油质量的3%、甲醇与环氧大豆油摩尔比13∶?1、反应温度75?℃，在此条件下大豆油基多元醇的转化率为77.25%。 |
| 英文摘要: |
| Preparation of soybean oil-based polyols catalyzed by phosphotungstic acid based (HPW-based) mesoporous sieve was optimized using response surface methodology. The results showed that using methanol as ring-opening reaction reagent，HPW-based mesoporous sieve could be successfully used as the catalyst for preparation of soybean oil-based polyols from epoxidized soybean oil. By the Box-Behnken design, the Design-expert 8.0 software was applied in square regression analysis. The optimal conditions for preparation of soybean oil-based polyols were obtained as follows: reaction time 3 h, dosage of HPW-based mesoporous sieve 3% (based on the mass of epoxidized soybean oil), molar ratio of methanol to epoxidized soybean oil 13∶?1 and reaction temperature 75?℃. Under the optimal conditions, the conversion rate of soybean oil-based polyols was 77.25%. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
